STANDARD WINCH
For Weld-on
Bottom Mounting
Part No. 1010102
LOW-PROFILE WINCH
For Weld-On
Side Mounting
Part No. 1010104
PORTABLE WINCH
Flexible Placement Along
Trailer Side Channel
Part No. 1010105
PORTABLE WINCH
Low Profile
Flexible Placement Along
trailer Side Channel
Part No. 1010106
STANDARD
SLIDING WINCH
Adjusts location by sliding
in track shown on this
page. Locks firmly in place
when under load
Part No. 1010108
STORABLE
SLIDING WINCH
Adjusts location by sliding
in track shown on this
page. Allows extra storage
of webbing
Part No. 5820
WINCH TRACK
For sliding winches. Steel.
In 6 foot lengths
Part No. 3606
WINCH BARS
A
B
C
Winch bars feature knurled slip-resistant handle
with carbon steel nose piece for strength.
A
Standard bar, chrome plated.
Part No. 1010107
B
Standard bar, painted.
Part No. 37030
C
Combination chrome plated winch bar features
modified handle for use in tightening chain
binders.
Part No. 10033
Warning: When tightening and
loosening winches, always maintain a firm grip on the winch bar.
Never release a winch
bar without checking the pawl to ensure that it
is fully engaged between ratchet teeth. Releasing the winch bar
without the
pawl being properly engaged can cause serious
injury to the user or bystanders. The use of a winch bar
specifically
designed to loosen or tighten winches is
recommended. "Cheater bars" or extenders should not be used with the
winch
bars. The tip of the winch bar should be
inserted through both holes in the end cap of the winch to prevent
the winch bar
from slipping out, and overloading the bar tip
or winch end cap.
WINCH STRAPS
4" WIDE WEBBING
Made from resin coated polyester for minimum
stretch
and maximum wear resistance. Labeled to meet
CVSA
guidelines, DOT regulations, and WSTDA
recommended
standards.
Webbing Breaking Strength:
20,000 lbs
Assembly Breaking Strength:
15,000 lbs
Working Load Limit:
5,000 lbs
27 Foot Strap Assembly: Part
No. 1010092
FLATBED CARGO CONTROL PRODUCTS
STANDARD
SLIDING WINCH
Adjusts location by sliding
in track 3608 only! Locks
firmly in place when
under load
Part No. 1020
